Buyrun çözüm :
Virtual Server
1. Launch the web console.
2. Click on Advanced Setup
3. Click on NAT
4. Set NAT options to NAT RULE entry
5. Click on ADD
6. Set the rule flavor to RDR
7. Set Rule ID to next available # (example if you have 4 ID's open then 5 would be next)
8. IF name: set to ALL
9. Protocol is the type of port (example TCP* UDP)
10. Type in the local address of the computer your accessing or range of computers you wants that port open on. To and from should be the same address if assigning this to a single IP.
11. Leave both Global Address to and from: set to all zeros.
12. Destination Port From: this is the port you need opened.
Destination Port To: this is the port you need opened.
Local Port: this is the port you need opened.
13. then click on Save changes
DMZ
1. Launch the web console.
2. Click on Advanced Setup
3. Click on NAT
4. Set NAT options to NAT RULE entry
5. Click on ADD
6. Rule ID: to next available # (example if you have 4 ID's open then 5 would be next)
7. IF name: set to "ALL
8 Protocol is "any"
9. Local Address From: add the IP address for your DMZ
10. Local Address To: add the IP address for your DMZ
11. Both Global address's "From & To" are set to "0"
12. Destination Port From: Any other port 0
13. Destination Port To: Any other port 65535
14. Local Port: Any other port 0
15. save changes
Virtual Server
1. Launch the web console.
2. Click on Advanced Setup
3. Click on NAT
4. Set NAT options to NAT RULE entry
5. Click on ADD
6. Set the rule flavor to RDR
7. Set Rule ID to next available # (example if you have 4 ID's open then 5 would be next)
8. IF name: set to ALL
9. Protocol is the type of port (example TCP* UDP)
10. Type in the local address of the computer your accessing or range of computers you wants that port open on. To and from should be the same address if assigning this to a single IP.
11. Leave both Global Address to and from: set to all zeros.
12. Destination Port From: this is the port you need opened.
Destination Port To: this is the port you need opened.
Local Port: this is the port you need opened.
13. then click on Save changes
DMZ
1. Launch the web console.
2. Click on Advanced Setup
3. Click on NAT
4. Set NAT options to NAT RULE entry
5. Click on ADD
6. Rule ID: to next available # (example if you have 4 ID's open then 5 would be next)
7. IF name: set to "ALL
8 Protocol is "any"
9. Local Address From: add the IP address for your DMZ
10. Local Address To: add the IP address for your DMZ
11. Both Global address's "From & To" are set to "0"
12. Destination Port From: Any other port 0
13. Destination Port To: Any other port 65535
14. Local Port: Any other port 0
15. save changes